Portfolio- Breadboard power supply

233

 Redesigned By: SAGAR SAPKOTA    (contact)          

(Original design by Sparkfun.com.)


 Here is a very simple breadboard power supply kit that takes power from a DC wall wart and outputs a selectable 5V or 3.3V regulated voltage. The .1″ headers are mounted on the bottom of the PCB for simple insertion into a breadboard. Pins labeled VCC and GND plug directly into the power lines. The lone pair of pins have no electrical connection but help support the PCB.

There are two pins available within the barrel jack footprint. Any stripped +/- DC supply can be connected instead of the barrel connector. Board has both an On/Off switch and a voltage select switch (3.3V/5V).

Comes as a bag of parts kit and is easily assembled if you can follow the silkscreen indicators and have beginning experience with a soldering iron. You will need to read the resistor bands or use a multimeter to determine the resistor sizes.


You can buy the kit at buildcircuit.net

breadboard power supplyBuy now button


Documents:


EasyEDA: Ideas for Circuit Design, Innovation for Electronics Access

Free Circuit Design: Schematic - Simulation - PCB Layout - Gerber Viewer

JLCPCB Prototype & Small-batch PCB: Only $2 for 10pcs 10×10cm PCBs, 24 hours Quick Turn, DHL Delivery in 3 Days

LEAVE A REPLY