Latch-up circuit using 555 and opto-coupler

Here’s a simple latch-up circuit using 555 timer and opto-coupler MCT2E. You can also use PC817 in place of MCT2E.  The NE555 timer is configured in astable mode.The components are selected in such a way that the frequency output of the astable circuit lies within the audio range. Opto-coupler, MCT2E is is used for latching the alarm.Under normal conditions, pin 4 of NE555 timer is set to ground via resistor R2(470Ohm) and its output at Pin 3 is held LOW. When switch S1 is pressed momentarily, transistor T1 (BC548) conducts to bring reset pin 4 to logic “HIGH” state, as a result, 555 timer activates and starts the sound and the LED inside the optocoupler glows and the phototransistor conducts. The transistor gets base bias via phototransistor and resistor R6(470R). The sound remains ON till you press the reset switch(S2).  When switch S2 is pressed, the base of the transistor connects to the ground(0V) and resets the 555 timer bringing Pin 4 to LOW state. This disables the alarm. (more…)

Search for products

Back to Top
Product has been added to your cart