How to program Amarino lamp

410

To know about Amarino lamp, visit this page. 

Amarino lamp is fully programmable. The kit package consists FTDI basic breakout board, you can use it to program the lamp. The lamp is based on Arduino.

Connect the FTDI basic breakout board to the lamp, open the Arduino programming interface and upload your sketch.

REMEMBER: Turn off the red colored 1P DIP switch 1-position-2p-side-style-dip-switch-redwhile uploading sketch(if the Bluetooth module has been stacked over the 4 pin female header)

programming

Documents: 

  1. About Amarino Lamp
  2. Assembly Tutorial
  3. Amarino Lamp- Light sensor
  4. Lamp test with different phone sensors
  5. How to program Amarino lamp

Where can you buy ?

buildcircuit    etsy

EasyEDA: Ideas for Circuit Design, Innovation for Electronics Access

Free Circuit Design: Schematic - Simulation - PCB Layout - Gerber Viewer

Cheapest PCB Prototype: Only $2 for 10pcs 10×10cm PCBs, 24 hours Quick Turn, DHL Delivery in 3 Days

LEAVE A REPLY